422 Ohm resistor discharge
9 V NiMH battery

First posted
Tuesday December 18, 2012 11:58
Updated
Friday December 21, 2012 08:59

____

Tuesday December 18, 2012 14:00

Discharge of NiMH with 98025 at about .9 mA may take weeks. But the 98025 test set-up is instructive.

So lets speed up the discharge rate.

422 Ohm resistor will discharge a 9 V NiCD or NiMH battery at roughly

9/422 =.0213 A = 21.3 mA.

Author photo Tuesday December 18, 2012



Video of script points.

1 bill payne
2 albuquerque, NM Tuesday December 18, 2012.
3 Possible large scale solar generation of electricity scam investigation.
4 Wind might be a scam too because of mechanical problems, lots of electronics which may be irreplaceable, intermittent wind, revenue from electricity produced by turbine does not pay for turbine and maintenance?
5 Well-educated scam artists.
6 Liberal arts 'educated' decision makers.
7 Solar generation of electricity scalability. Fast Neutron.
8 You can learn as much about solar generation of electricity from small solar cells and small batteries as you can from utility large-scale systems.
9 Solar generation of electricity works well if matched to the electric load. Solar gate openers.
LED garden lights. Speed displays. Galesteo, NM.
10 Listened to solar home systems pitches. And mp3 recorded and posted Affordable Solar pitch!
11. Stop talking and start DOING. :) 

Friday December 21, 2012 08:55

Meter left on NiMH #1 Thursday until Friday moring.

 



Real dead.

Wednesday December 19, 2012 12:24

Tuesday December 18, 2012 after about 5.5 hours of opertaion.




8.46 / 422 = 20.05 mA

After over 22 hours of operation on Wednesday December 19, 2012



3 / 422 = 7.1 mA.

Battery voltage and charge tests.



No load on battery so voltage rises.



Meter battery load of 370 milli Ohm.

Should be about 25 imA f battery is charged but, as seen, it is 6.46 mA.

Next step is to charge using a grid charger.

Battery will be discharged again then battery will be charged with a solar charger. :)


Into the garage to retrieve our resistor/capacitor library.



One percent precision resistor in library.

And the meter is free! :)

Below tests run Tuesday December 18, 2012.



T44 pins soldered to battery leads.

No load on battery # 1 voltage



Battery test should read above 24 if battery is charged according to 69096 Operating instructions.




Left meter measures voltage across battery #1.

Right meter measure IR drop across the 422 Ohm resistor but ground wire not connected.




Ground wire connected.



9.2 V/422 = 21.18 mA. :)

No meter to measure amps required in this experiment.

Heat from resistor felt when finger placed on it.

NiMH battery is used to power heater!

3412.14164 BTU = l KWh is critical for identifying altenergy BS as well as is the second law of thermodynamics.
Obama Calls For Repeal of Laws of Thermodynamics


Associated Links


Battery Charging AA, AAA, 9V NiCd and NiMH.






Anita Langley.
Sahar Mehrroz.





Jason Marks is liberal arts 'educated'.




This page is formatted with CSS by the author